For installation stretch ceiling, first of all you need to do marking the wall by water level, or using a laser. After marking the wall is necessary to determine precisely the place of lamps.We are using special lath.
After marking wall fasten profile.In the necessary places, doing bends.
Then, we need sticking duct tape on all joints profiles.This is necessary in order to avoid damaging the material during assembly.
Then fasten the ends of the fabric, to the corners of the walls.
Further ,for this mountinq we use burner.
For lamps there is a special plastic circle.Sticking the circle to the place of the light, and wait for its drying. Next, cut out a place for the light.
Then, fastened the decorative insert around of the ceiling.
That's all.
|