Home » stages of repair walls
For this work we need a smooth and flat surface of the wall. If there is old paint or old wallpaper, their need to overcome as far as possible. After cleaning the wall, make wall primer, after that fasten the grid, but you can completely do without it. For decorative stone stickers use special glue. Diluting with water in appropriate amounts, and apply the adhesive and the wall and the tiles.
...
Read more »
|
For applying liquid wallpaper on the wall, the wall should be initially primed, remove old wallpaper, word walls must be smooth and clean.
Then take the bucket warm water 30-35 degrees and damp our wallpaper. If there is any color additives, dilutes them first and then our wallpaper.
...
Read more »
|
With painting the walls can handle every.Only need to take a bucket of paint and a roller for applying a layer on the wall.A wall must first be primed.Degrease the wall primer, we thereby improve the absorbing of paint to the wall.In this case the most important thing to avoid stains and drips paint on the wall.In short ,as not, like that.
And where necessary, use masking tape to not gloss over anything.
...
Read more »
|
For this purpose, it is necessary to build a grid of metal profiles.
To carcass construction, it is necessary to draw a straight line on the floor, ceiling or wall, with using a laser.
Fasten the c shaped profils, using screws on this straight line.
...
Read more »
|
If you decide to sheathe wall, with panels PVC, you will need the following steps:You need to make a mark on the wall, using a builder's level.
Then, crate wall. First of all fasten the brackets to the wall. Farther, fasten c shaped profile on the brackets.
...
Read more »
|
The next stage is the primer.
Priming the ceiling, the walls should be done to protect against mold different dirt.
Now, you need to pour the liquid into a bowl, and apply the wall, ceiling, and floor.It is environmentally friendly, and not dangerously for health.&
...
Read more »
|
The next stage will be to hang wallpaper. Purging it of old wallpaper, or peeling paint, putty.
After, you need to crop the wallpaper, and smear the glue, on the wall and on the wallpaper.
![](<!--"--)
...
Read more »
|
After the plaster, you need putty wall.
Putty is applied to the wall in two layers. After the first coat has dried, apply a second. For preparation of putty, you need to take a bucket of water, a spatula and pour plaster on the surface of the water, and thoroughly kneading.
All the mixture is ready for application. Ok, after the completion of all work, you need to clear the wall with sandpaper, from ledges, irregularities and so on.
...
Read more »
|
Plaster walls, done in the first place, and require special skills. You need to prepare a solution of cement and sand. We need to interfere with 3 shovels of sand, and 1 shovel cement. After adding water, we mix solution.
Now, you need to make the beacon on the wall. We need two great snipe, one is nailed on top, the other below.
Then put a profile on the great snipe, and measure the curvature, using a spirit level.And&nbs
...
Read more »
|
|
|